Мануал по мазда 929

Войдите или зарегистрируйтесь, чтобы писать комментарии, задавать вопросы и участвовать в обсуждении.

Mazda 929 workshop manual (инструкция по ремонту Mazda 929), 1983-1986 г.в., 2.0, english, 28.3 Mb, PDF.

download \ ссылка 

Условия:

1. Поставьте автомобиль на стояночный тормоз.
2. Убедитесь, что УОЗ, свечи зажигания, поплавок в карбюраторе и т.д., все в нормальном рабочем состоянии.
3. Прогрейте двигатель до нормальной рабочей температуры, после чего продержите обороты в течение трех минут на уровне 2000 об\мин.
4. Выключите все аксессуары.
5. Подключите точный тахометр к двигателю.
6. Подключите газоанализатор.

Обороты холостого хода:

1. Проверьте обороты холостого хода и, при необходимости, откорректируйте их, поворачивая регулировочный винт дросселя.

Обороты холостого хода:

МКПП 800±50 rpm на нейтрали
АКПП 900±50 rpm на «N»

2. Убедившись, что холостой ход в пределах спецификации, проверьте концентрацию СО. Если необходимо, откорректируйте концентрацию в соответствии со следующей процедурой.

Смесь:

1. После регулировки оборотов холостого хода, снимите заглушку с винта регулировки смеси.
2. Отрегулируйте концентрацию СО до 2,0 ± 0,5% поворотом регулировочного винта.
3. Если число оборотов холостого хода отклоняется от нормы, отрегулируйте его, поворачивая регулировочный винт дросселя.
4. Закройте винт регулировки новой заглушкой

To change a flat tire on your Mazda 929, start by locating the spare tire, jack, and lug wrench. Loosen the lug nuts before jacking up the car. Once the car is lifted, remove the lug nuts and take off the flat tire. Install the spare tire and hand-tighten the lug nuts. Lower the vehicle and then tighten the lug nuts with the lug wrench.

To change the cabin air filter in your Mazda 929, start by locating the filter housing, which is typically located behind the glove compartment. Remove the access panel or clips to gain access to the filter. Take out the old filter and replace it with a new one, ensuring it is properly aligned. Reassemble the housing and test the air conditioning or heating system to confirm proper operation.

To change the oil in your Mazda 929, start by locating the oil drain plug underneath the car. Use a wrench to remove the drain plug and let the old oil drain into a container. Once the oil has fully drained, replace the drain plug and remove the oil filter. Install a new oil filter, then refill the engine with the recommended amount and type of oil.

To check the tire pressure on your Mazda 929, start by locating a tire pressure gauge. Unscrew the valve cap from each tire and press the gauge onto the valve stem firmly. Read the pressure indicated on the gauge and compare it to the recommended tire pressure listed in the owner’s manual or on a sticker located inside the driver’s door jamb. Add or release air as needed to match the recommended pressure.

When diagnosing a faulty alternator in your Mazda 929, start by checking the battery voltage with the engine off and then with the engine running. A healthy alternator should provide a voltage higher than the battery’s resting voltage when the engine is running. If the alternator fails this test, it may need to be replaced. Consult a Mazda 929 automotive repair manual or seek professional assistance for the specific repair procedures.

To replace a broken side mirror on your Mazda 929, start by removing the interior door panel to access the mirror mounting bolts. Disconnect the electrical connector if applicable, then remove the bolts securing the mirror. Install the new mirror by reversing the steps and ensure it is securely attached. Test the mirror’s functionality before completing the reassembly.

To replace a burnt-out headlight bulb on your Mazda 929, start by accessing the headlight assembly from under the hood. Remove the electrical connector from the back of the bulb and then twist the bulb counterclockwise to remove it. Install the new bulb by reversing the steps and ensure it is properly secured. Test the headlights to confirm the replacement was successful.

To replace the brake pads on your Mazda 929, start by lifting the car using a jack and securing it with jack stands. Locate the brake caliper and remove the bolts holding it in place. Carefully remove the caliper and then the old brake pads. Install the new brake pads and reassemble the caliper, ensuring it is properly aligned. Finally, test the brakes before driving the vehicle.

To reset the maintenance light on your Mazda 929, start by turning the ignition to the «on» position without starting the engine. Press and hold the trip/reset button located on the instrument panel until the maintenance light starts flashing. Release the button and turn off the ignition. The maintenance light should now be reset.

When troubleshooting a faulty electrical system in your Mazda 929, start by checking the fuses to ensure they are not blown. Inspect the battery terminals for corrosion or loose connections. Use a multimeter to test the voltage at various points in the electrical system, such as the battery, alternator, and starter. If the issue persists, it is recommended to consult a Mazda 929 automotive repair manual or seek professional assistance.

The air filter in your Mazda 929 should be replaced according to the manufacturer’s recommendation, which is typically every 15,000 to 30,000 miles or as stated in the owner’s manual. However, if you frequently drive in dusty or polluted areas, it is advisable to check and replace the air filter more frequently to maintain optimal engine performance.

The timing belt in your Mazda 929 should be replaced according to the manufacturer’s recommended interval, which is typically around 60,000 to 100,000 miles or as stated in the owner’s manual. It is crucial to replace the timing belt within the specified interval to prevent potential engine damage if the belt were to fail.

If the check engine light in your Mazda 929 comes on, it is advisable to have the vehicle inspected by a qualified mechanic. The check engine light indicates that there may be an issue with the engine or emissions system. Continuing to drive the vehicle without addressing the underlying problem could potentially cause further damage.

If your Mazda 929’s engine overheats, the first step is to pull over to a safe location and turn off the engine. Allow it to cool down before attempting to check the coolant level or open the radiator cap. Once it has cooled down, check the coolant level and add more if necessary. If the issue persists, it is recommended to have your vehicle inspected by a professional mechanic.

For your Mazda 929, it is recommended to use automatic transmission fluid that meets the specifications outlined in the owner’s manual. Consult the manual for the specific viscosity and type of transmission fluid suitable for your vehicle. It is crucial to use the correct fluid to ensure smooth operation and longevity of the transmission.