Мануал хонда цивик 2001 2005

Похожие темы

Ваши права

Quick Links

• Page 2: Table Of Contents

  Contents Introduction … 3 Emergency Disarming During Alarming … 4 During the Entry Delay Time … 4 System Controls Arming Mode (MANUAL AUTO) … 5 Arming Mode (AUTO MANUAL) … 6 Valet (Auto Arming Mode only) Placing the System in the Valet Mode … 7 In the Valet Mode …

• Page 3: Introduction

  Congratulations on your purchase of this Honda Security System. Your Honda Security System is the product of years of research and development. It will give you many years of reliable performance, protection, and convenience. The system consists of two major components: a main unit and a remote control transmitter.

• Page 4: Emergency Disarming

  Emergency Disarming During Alarming During the Entry Delay Time • The system can be disarmed using the ignition key regardless of the method used to arm the system. • This method of disarming also serves as an emergency override if the remote control transmitter cannot be used.

• Page 5: System Controls

  Arming Mode (MANUAL AUTO) 4713010M 4713010M © 2008 American Honda Motor Co., Inc. — All Rights Reserved. This section explains how to switch the arming mode from MANUAL to AUTO. Note: Factory preset is MANUAL. Disarm the security system. Steps from 2 to 4 must be completed within 3 seconds. Insert the ignition key, and remove the ignition key from the ignition switch.

• Page 6: Arming Mode (Auto Manual)

  System Controls Arming Mode (AUTO MANUAL) 4713010M 4713010M This section explains how to switch the arming mode from AUTO to MANUAL. Turn the ignition key to the OFF position. Remove the key from the ignition switch. Open a door and close it. (The EXIT delay starts.) Steps from 4 to 6 must be completed within 3 seconds.

• Page 7: Valet (Auto Arming Mode Only)

  Placing the System in the Valet Mode (Valet Mode cannot be used in the Manual Arming Mode) 4713010M 4713010M Status LED © 2008 American Honda Motor Co., Inc. — All Rights Reserved. Valet (Auto Arming Mode only) When the security system is placed in the valet mode, it is temporarily placed on hold.

• Page 8: In The Valet Mode

  Valet (Auto Arming Mode only) In the Valet Mode: Keyless/Security during the Valet Mode. Lock/Unlock of Keyless VALET MODE is ON Active VALET MODE is OFF Active If you follow either procedure below, LED blinks once to show the system is in the Valet mode.

• Page 9: Exit From The Valet Mode

  Exit from the Valet Mode 4713010M 4713010M Status LED © 2008 American Honda Motor Co., Inc. — All Rights Reserved. Valet (Auto Arming Mode only) With the system in the Valet mode and the key out of the ignition switch Steps from 2 to 4 must be completed within 3 seconds.

• Page 10: Arming

  Arming Arming Methods Manual Arming (Remote Controlled) There are two possible ways to arm the system: • MANUAL Arming (Remote Controlled). • AUTO Arming (Passive) • When the main unit is set to “MANUAL,” the system is armed by using the remote control transmitter.

• Page 11: Auto Arming (Passive)

  • When the main unit is set to “AUTO,” the system arms automatically 20 seconds after the Auto Arming (Passive) • If a door or the trunk (tailgate) is opened during the 20 second exit delay time, the timer resets (Arms the security system without locking the doors.) •…

• Page 12: Alarm Mode

  Alarm Mode Alarm Triggered Mode • After the system is armed, opening of any doors or the trunk (tailgate) will trigger the alarm. • If the door(s) is kept open, the alarm will continue to sound for 10 minutes. • If the battery is disconnected in the alarm mode, any attempt to reconnect the battery will send the alarm into the triggered mode.

• Page 13: Disarming

  Remote Controlled Disarming © 2008 American Honda Motor Co., Inc. — All Rights Reserved. Regardless of the method used to arm the system, the system can be disarmed using the remote control transmitter. Press the “UNLOCK” button once on the remote control transmitter and the following will occur.

• Page 14: Panic

  Panic Activating the Panic Function 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 Deactivating the Panic Function 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 •…

• Page 15: Tripped Sensor Warning And Indication

  Tripped Sensor Warning and Indication • The system will warn you that the security system has been tripped in your absence. Tripped Sensor Warning • If the system was tripped and auto rearmed you will observe the following: The status LED flashes twice per second. The parking lights flash 3 times when the system is disarmed.

• Page 16: Tripped Sensor Indication (Using Both The Transmitter And Ignition Key)

  Tripped Sensor Warning and Indication Tripped Sensor Indication (using both the transmitter and ignition key) • After disarming the system, if the tripped sensor warning indicator appears, you can identify which sensor has been tripped by observing the number of flashes as shown below.

• Page 17: Tripped Sensor Indication (Using Only The Ignition Key)

  Tripped Sensor Indication (using only the ignition key) TRIPPED STATUS LED SENSOR NUMBER OF FLASHES Door (tailgate) Trunk Ignition Key Switch Ignition Switch Battery Disconnected © 2008 American Honda Motor Co., Inc. — All Rights Reserved. Tripped Sensor Warning and Indication Disarm the security system.

• Page 18: Remote Control Code Programming (Only Vehicles Without Power Door Locks)

  Remote Control Code Programming (Only vehicles without Power Door Locks) How to Program Remote Control Transmitters • For steps 2 through 12, each step must be completed within 5 seconds. For step 13, within 10 seconds for each remote. • Up to four remotes can be stored in memory. •…

• Page 19
  Remote Control Code Programming (Only vehicles without Power Door Locks) © 2008 American Honda Motor Co., Inc. — All Rights Reserved. Press the “LOCK” or “UNLOCK” button on the remote control transmitter. Turn the ignition to the “OFF” position. Turn the ignition to the “ON” position. Press the “LOCK”…
• Page 20
  Remote Control Code Programming (Only vehicles without Power Door Locks) Press the “LOCK” or “UNLOCK” button on the remote control transmitter. • The Status LED illuminates simultaneously for 1 second to indicate programming mode. • To terminate the programming mode at this point, either turn the ignition key to the “OFF”…

• Page 21: Glossary

  ALARM DURATION AUTOMATIC ARMING MANUAL ARMING DISARM ENTRY DELAY TIME EXIT DELAY TIME Functional only in the Automatic Arming mode. © 2008 American Honda Motor Co., Inc. — All Rights Reserved. Description The amount of time the horn sounds when the alarm is tripped or the panic feature is activated.

• Page 22
  Glossary EXTENDED EXIT ARMING PANIC SENSOR CANCELLATION TRIPPED SENSOR INDICATION TRIPPED SENSOR WARNING VALET Functional only in the Automatic Arming mode. Description If a door or the trunk (tailgate) is opened during the exit delay time, the timer will reset itself and will restart the count down procedure when that door or trunk is closed.
• Page 23
  Notes © 2008 American Honda Motor Co., Inc. — All Rights Reserved.

• Page 24: Specifications

  Specifications Main Unit Design … Microprocessor, all solid state Operating Voltage … 13 V DC (9 V to 16 V allowable) Current Consumption (Arming) … 2 mA Operating Temperature … -40°C to + 80°C (-40°F to +176°F) Dimensions … 84 mm x 65 mm x 28 mm (3-5/16″…