Мануал для сузуки балено

58, 2-39 BEFORE DRIVING 68PM2-01E Installation suitability of ISOFIX child restraint systems Mass Group Size class Fixture Vehicle ISOFIX positions Front Passenger Rear Outboard Rear Center Intermediate Outboard Intermediate Center Others sites carrycot F ISO/L1 N.A. X N.A. N.A. N.A. N.A. G ISO/L2 N.A. X N.A. N.A. N.A. N.A. group 0 up to 10 kg E ISO/R1 N.A. IL N.A. N.A. N.A. N.A. group 0+ up to 13 kg E ISO/R1 N.A. IL N.A. N.A. N.A. N.A. D ISO…

300, 5-35 OTHER CONTROLS AND EQUIPMENT 68PM2-01E Maintenance If you do not use the air conditioner for a long period, such as during winter, it may not give the best performance when you start using it again. To help maintain opti- mum performance and durability of your air conditioner, it needs to be run periodically. Operate the air conditioner at least once a month for one minute with the engine idling. This circulates the refrigerant and o…

130, 2-111 BEFORE DRIVING 68PM2-01E Warning and indicator lights NOTE: If warning and indicator lights blink or come on, the corresponding messages may be shown on the information display. Low tire pressure warning light 52D305 As an added fuel efficiency feature, your vehicle is equipped with a tire pressure monitoring system (TPMS) that uses a low tire pressure warning light to inform you when one or more of your tires is signifi- cantly under-inflated. When the ignition switch is turned to �…

126, 2-107 BEFORE DRIVING 68PM2-01E Warning and indicator message Master warning indicator light Sound Cause and remedy 68PM00295 Blinks Beep (one time from interior buzzer) Change the engine oil and oil filter immedi- ately. The oil life monitoring system must be reset after changing the engine oil and oil filter. Refer to “Oil change request light” in this section.
…

238, 3-79 OPERATING YOUR VEHICLE 68PM2-01E Rearview camera (if equipped) When the gearshift lever is shifted to “R” position while the ignition switch is in “ON” position or the ignition mode is “ON”, the rearview camera system automatically shows the view behind the vehicle on the display. Rearview camera location 68PM00347 (1) Rearview camera The rearview camera is installed beside the license plate light. WARNING The distance viewed in the rearview camera may differ …

167, 3-8 OPERATING YOUR VEHICLE 68PM2-01E Every time you press the engine switch, the ignition mode changes as follows. Manual transaxle 68PH00322 Automatic transaxle or CVT 57L31006 NOTE: • Automatic transaxle or CVT – If the gearshift lever is in any position other than “P”, or if the knob button is pushed when the gearshift lever is in “P” position the ignition mode cannot be returned to “LOCK” (OFF). • When selecting the ignition modes, the information display in the …

123, 2-104 BEFORE DRIVING 68PM2-01E (#1) This message will disappear for a while even if the problem that caused the message to appear is not corrected. Warning and indicator message Master warning indicator light Sound Cause and remedy 68PH02243 Off Off This message is displayed when “ON” posi- tion is selected as the power supply posi- tion. (#1) 68PH02244 Blinks Beep (one time from interior buzzer) The ste…

256, 3-97 OPERATING YOUR VEHICLE 68PM2-01E The tire pressure monitoring system, trans- mitter model S180052024 and receiver model 40398036 are in compliance with the essential requirements and other rele- vant provisions of Directive 1999/5/EC.
…

333, 5-68 OTHER CONTROLS AND EQUIPMENT 68PM2-01E 5) Selecting “Go Back” or pressing the BACK button (4) stores displayed set- ting and the previous menu is dis- played. Making a call by phonebook Follow the instructions below to dial a num- ber registered in phonebook. 1) Press OFF HOOK button (7). The Bluetooth ® phonebook menu will be displayed. 2) Turn “TUNE/FLD PUSH SOUND” knob (1) to select “Phonebook”, and press the knob (1) to determine the selection. 3) Turn “TU…

82, 2-63 BEFORE DRIVING 68PM2-01E 68PM00249 (3) Information display When the ignition switch is in “ON” posi- tion, the information display shows the fol- lowing information. Display (A) Clock Display (B) Fuel gauge Display (C) Trip meter / Odometer / Fuel consumption / Driving range / Oil indicator Display (D) Gearshift indicator Display (E) Thermometer Clock When the ignition switch is in “ON” posi- tion, the display (A) shows the time. To change the time indication: …

336, Suzuki Baleno 5-71 OTHER CONTROLS AND EQUIPMENT 68PM2-01E 3) Turn “TUNE/FLD PUSH SOUND” knob (1) to select “Passkey”, and press the knob (1) to determine the selection. 4) Turn “TUNE/FLD PUSH SOUND” knob (1) to select “Enter New Passkey”, and press the knob (1) to determine the selection. 5) Press or turn “TUNE/FLD PUSH SOUND” knob (1) to select “Confirm”. 6) Turn “TUNE/FLD PUSH SOUND” knob (1) to select…

226, 3-67 OPERATING YOUR VEHICLE 68PM2-01E • In the following situations, the radar sen- sor might not function properly. Turn it off and have it inspected by an authorized SUZUKI dealer. – When there is a minor crash and the radar sensor is damaged or hindered – When the warning brake system and automatic brake system are activated more than necessary 54P000337 68PM10301 • When you want to turn off the system, push an…

332, 5-67 OTHER CONTROLS AND EQUIPMENT 68PM2-01E 6) Turn “TUNE/FLD PUSH SOUND” knob (1) to select a number to be deleted or “ALL”, and press the knob (1) to deter- mine the selection. 7) Turn “TUNE/FLD PUSH SOUND” knob (1) to select “Delete?” or “Delete All?”, and press the knob (1) to determine the selection. Turn “TUNE/FLD PUSH SOUND” knob (1) to select “Confirm”, and press the knob (1) to complete the deletion. NOTE: When selecting “Go Back” or pressing…

24, 2-5 BEFORE DRIVING 68PM2-01E 54P000259 To release this system: To unlock the driver’s door, insert the key in the driver’s door lock and turn the top of the key toward the rear of the vehicle once. NOTE: You can switch the function that unlocks all doors from requiring two turns to requiring one turn, and vice versa, via the informa- tion display setting mode. For details on how to use the information display, refer to “Information display” in this section…

396, Suzuki Baleno 7-39 INSPECTION AND MAINTENANCE 68PM2-01E 60G104S Parking brake 54G109 Ratchet tooth specification “b”: 4th – 9th Lever pull force (1): 200 N (20 kg, 45 lbs) Check the parking brake for proper adjust- ment by counting the number of clicks made by the ratchet teeth as you slowly pull up on the parking brake lever to the point of full engagement. The parking brake lever should stop between the s…

439, 9-4 APPEARANCE CARE 68PM2-01E Washing 60B212S When washing the vehicle, park it in the place where direct sunlight does not fall on it and follow the instructions below: 1) Flush the underside of body and wheel housings with pressurized water to remove mud and debris. Use plenty of water. 2) Rinse the body to loosen the dirt. Remove dirt and mud from the body exterior with running water. You may use a soft sponge or brush. Do not use hard materials which…