Лего техник феррари инструкция по сборке

Need building instructions for your Lego set 42143 Technic Ferrari Daytona SP3? Below you can view and download the PDF building instructions for free. There are also frequently asked questions, a product rating and feedback from users to enable you to optimally use your product. If this is not the manual you want, please contact us.

Is your product defective and the manual offers no solution? Go to a Repair Café for free repair services.

Updated 09/01/2022

The LEGO Technic 42143 Ferrari Daytona SP3 is a great 1:8 scale supercar set, you can check my detailed building reviews here. Unfortunately the building instructions were released originally with several errors, I created this blog post to list what was found by myself and the community, and an indication whether they were corrected in the digital version or not.

The manual received a bigger update at the end of August 2022, the major issues are now fixed, as previously I strongly suggest to use the digital version of the manual.

You can see all the previously found issues listed below, with the indication whether it is fixed now in the latest digital version of the instructions or not.

Here’s the video about all the changes:

Step 88 (fixed)

In the paper manual the orientation of the 2 orange wave selectors and the green 2L beam relative to each other was incorrect, more details about this in my video. In the updated version the 2 orange wave selectors are rotated, but their position was not updated in the previous or following steps so you need to pay extra attention. They should look exactly like this when you add the green 2L beam:

Step 104 (fixed)

The part usage callout on top was incorrect, you have to use the part at the bottom and not the one on the top, the green checkmark and the red X was swapped.

Step 219 (not fixed yet)

This is not really an error, but easy to misunderstand. The assembly image shows the light bluish grey bush in the middle of the axle, but when you push the axle in place the bush has to be closer to the end that goes in the orange connector

Step 240 (not fixed yet)

A minor error, if the knob gear is in this position forming an X then the axle cannot be inserted in this position forming a +. Both the axle and the knob gear will have the + orientation when inserted in place.

Step 255 (not fixed yet)

There’s an L beam with blue and black pins added at step 250, their position is correct. At step 255 the position of the black pin is shown incorrectly, it should be in the hole closer to the horizontal beam as it was shown correctly in the previous steps:

Step 1115 & 1127 (fixed)

There are 2 black small panel fairings (#21 and #22) that you will find in the box and also in the inventory, but they are not used in the paper instructions:

Step 1122 (fixed)

There was an error in this step, compared to step 1110 the sub-assembly was not mirrored properly, now it is fixed:

Step 1267 (not fixed yet)

The 1×2 bricks holding the L Technic beam cannot be attached in this exact position to the plate, they have to be shifted half stud towards the upper edge:

Haven’t got this set yet?

Check out here…

Choose your local online LEGO Store below to get the 42143 Ferrari Daytona SP3.

lego.com US / lego.com UK / lego.com AU

Disclaimer: the post contains affiliate links, they won’t cost you extra money but any purchase made through them might help to run the site with a small commission.